I woke up at 7:30, played games, and then got up for pet stuff and breakfast. After that it was surfing until Abby was ready to run.
It was a little hot out, but Abby still had a good time. We only went to I5 and back because there were a fair number of shooters out.
When I got back it was time to fix the trailer floor. I cleaned out the edges with dental picks and used them to apply the adhesive, too. They worked well. I used a can of pumpkin to roll it out and cases of shells to weight it down. It was a lot of time laying on the floor. Ellen helped by handing me things so I didn't have to get up. I hope the fix works.
Ellen told me that there was a new Samsung watch with a rotating bezel. I want one. I can even get a $250 trade in for my old watch. I need to wait a couple of weeks for it's introduction, but I still spent some time on the web reading about it. That way I'm sure that I want one.
I noticed that my watch wasn't talking to the phone. Reconnecting it involved rebooting it. When I did it lost its mind. I spent a lot of time getting it back to what I wanted.
The 6X6 truck and its motor came today. They were delivered to the club. I opened it up and got out the instruction book. I needed two servos and a receiver to build it. I lucked out on Amazon. It's Prime day and the servos were on sale, cheap. I also found a case-less receiver that is cheap and small. I ordered one of those for the micro-b and will use the one I have now on the 6X6. It turns out that the kit has some, but not all, bearings. I ended spending a few bucks on Aliexpress that I didn't have to.
I switched to videos, which turned into a nap. Ellen's asshole was giving her grief, so I had a sandwich for dinner. After dinner I watched videos for a while and then switched to a movie. I only got halfway through the movie before I got bored and went to bed.
Tomorrow we have to be on the road before 9 to make the shoot.
No comments:
Post a Comment